The Vaporesso Sky Solo Plus is an all-in-one (AIO) kit that looks a lot like other pen-style vape<\/a> sets. It’s a high-quality tube-shaped vape battery with a tank on top that is mounted into the battery base. The tank on the Sky Solo Plus is integrated into the package, so you can’t just take it out and swap it with another.<\/p>\n It comes in a variety of colors. The battery compartment of the package has a good matt finish that repels fingerprints. The Vaporesso Sky Solo Plus branding runs the length of the unit, and there is a big, textured fire press.<\/p>\n The gadget is light to wear, weighing just 136g, but it does not feel cheap or flimsy. When you take a vape on the unit, an indicator light around the fire button lets you know the battery level. A micro USB port is available for connecting the charging cord. This is on the opposite side of the fire handle, 90 degrees clockwise.<\/p>\n The base of the tank, which is integrated into the unit, is located around the top of the battery part. This is where you screw your coils in. The air holes are not reversible and are not cut into the tank frame. The bottle contains a whopping 8ml of e-juice.<\/p>\n The drip tip and top cap are made of plastic and are all one piece. The fill port is revealed by unscrewing the drip tip. This hole is large enough to accommodate most bottle ends, and it is also recessed, so if you miss the hole, the liquid will not spill over the sides and all over your system.<\/p>\n The Vaporesso Sky Solo Plus has a nice style. It has a plain, understated appearance. It has a nice textured feel to it on the side, is lightweight without feeling cheap, and has a nice textured fire press. Except under direct sunshine, the fire button is very sensitive, and the warning lights are bright and clear. You may have tried pen-style vapes before when the lights were so dim that you couldn’t see the battery level or where you’d closed the unit before placing it in your pocket if the sun was shining. On the Vaporesso Sky Solo Plus, there are no issues.<\/p>\n Either of the two given coils must be installed while using the Vaporesso Sky Solo Plus for the first time. The coil is screwed onto the battery tube’s end. You’ll need to prime your coil once you’ve finished. Dripping e-liquid into the wicking holes is one way to do this. Rep until the juice is no longer soaking through the cotton in each hole.<\/p>\n You may also apply a few drops to the cotton that can be seen through the coil’s top. This prevents the cotton from burning when you first turn on the unit because it is soaked with e-juice.<\/p>\n The glass tube is then slipped over the coil, snugly fitting on the o-ring at the top of the battery tube. Finally, secure the top cap to the coil’s surface. Make sure it is snug, but not too snug, or you’ll have trouble unscrewing them later! Simply unscrew the drip tip to reveal the filling hole and fill the tank with e-liquid. Squirt the liquid in and replace the drip tip until it’s finished.<\/p>\n To switch on the unit, simply push the fire button five times quickly. The light around the fire button would turn orange, blue, and then red. This indicates that the system has been switched on. Inhale when pressing and holding the fire button. Simply replicate the five fast presses of the fire button to turn the unit off. That’s all there is to it when it comes to using this unit.<\/p>\n VR:xtranxvaperversed: xnipsx\u00a0 xlinex :metax :nodesc:ppc8: :VSEX0011152022<\/p>\n\r\nBuild<\/h3>\n
Quality<\/h3>\n
Tank<\/h3>\n
Specifications<\/h3>\n
\n
Vaporesso SKY SOLO Vape Pen Starter Kit<\/h3>\n
\n
Includes<\/h3>\n
\n
$45.00<\/strike> \r\n \r\n <\/div>\r\n\r\n